Filter
Top Products
Installing 3Com Network Access Manager 25
Follow these steps to install the 3Com Network Access Manager
components:
1 Insert the 3Com Network Access Manager CD in the PC’s CDROM drive.
If Autorun is enabled on the PC, the installation starts automatically and
you can skip steps 2 and 3.
2 From the Start menu, select Run.
3 Type
D:\setup (substitute the appropriate letter of your CD-ROM drive
for D), and click OK.
4 A splash screen will display and the installer will check that:
■ .NET Framework version 1.1 or later is installed on the PC,
■ a supported version of Windows is installed on the PC, as shown in
Tabl e 5,
■ the PC is a member of a domain,
if any of the checks fail, an error message will display indicating the
problem and the installer will abort. You need to correct the problem
before restarting the installer.
If the checks are successful, the Welcome dialog is displayed, Figure 3.
Figure 3 InstallShield Wizard