Filter
Top Products
Add _:iosal _fo mat on
Printing
The printer is not operating even Disconnect the USBcable and turn off the camcorder and the printer. After
though the camcorder and printer are a short while, turn them on again, set the camcorder to (#/._/_ mode
correctly connected, and restore the connect on.
Others
Acamcorder,rattlingcan be heard from the Theisnotinternalamalfunction.lensfixture can move when the camcorder is turned off. This -
ListofMessages
CHANGETHE BATTERYPACK
CANNOTENTERTHE
(_ STANDBY MODENOW
UNABLETO RECOGNIZETHE
RECORDINGMODE OFTHE DISC
• TEMPERATURETOO HIGH
CANNOTRECORD
• TEMPERATURETOO HIGH
CANNOTREMOVEDISC
• CANNOTRECORD
• CANNOTRECORD
CHECKTHE DISC
REACHEDTHE MAXIMUM
NUMBER OFSCENES
CANNOTPLAY DISC
a.6.ai_o
Battery pack isexhausted. Replace or charge the battery pack,
The camcorder cannot enter the standby mode while the disc is being
recognized after first inserting it or if the remaining battery charge istoo low.
You inserted a type of disc not supported by this camcorder,
The disc may not be recognized by this can]corder if it was initialized or
recorded using a different device,
You inserted a disc recorded in a different television system (PALor SECAM).
The camcorder has exceeded its operational temperature, Disconnect the
compact power adapter and remove the battery pack, Let the camcorder cool
down before resuming use.
There is a problem with the disc, Replace the disc,
This message can also appear if condensation has formed, Wait until the
camcorder dries completely before resuming use.
The disc's recording surface may be dirty or scratched,
The maximum number of scenes has been reached, Delete some recordings
(DVD-RW inHDquality, or SDquality (VRmode)) to free some space or replace
the disc,
The disc is dirty or you attempted to play back a type of disc not supported by
this camcorder,
This message can also appear if condensation has formed. Wait until the
camcorder dries completely before resuming use.
23
39
5
32
114
43
5
114
106