PLAYBACK
178
IMPORTANT!
• Take care that you do
not block the
microphone with your
fingers.
• Good recording results
are not possible when
the camera is too far
from the subject.
• The (Audio) icon appears on the monitor screen
after audio recording is complete.
• You will not be able to record audio when remaining
memory capacity is low.
• You cannot add audio to the following types of
images.
— Movie images
— Images created with MOTION PRINT
— Protected snapshot (page 186)
• Audio that is re-recorded or deleted cannot be
recovered. Make sure you no longer need audio
before re-recording or deleting it.
Microphone
To re-record audio
1.
In the PLAY mode, use [̇] and [̈] to scroll
through snapshots until the one whose audio
you want to re-record is displayed.
2.
Press [MENU].
3.
Select the “PLAY” tab, select “Dubbing”, and
then press [̈].
4.
Use [̆] and [̄] to select “Delete”, and then
press [SET].
• If you merely want to delete the audio without re-
recording, press [MENU] here to complete the
procedure.
5.
Press the shutter button to start audio
recording.
6.
Recording stops after about 30 seconds or
when you press the shutter button.
• This deletes the existing audio and replaces it with
the new one.