Filter
Top Products
3-8
Cisco Video Surveillance 2600 IP Camera User Guide
OL-24127-02
Chapter 3 Configuring and Managing the IP Camera
Setup Windows
Table 3-3 describes the options in the Advanced Setup window.
Ta b l e 3-3 Advanced Setup Window Options
Option Description
CDP
Enable CDP (Cisco
Discovery Protocol)
Check this check box if CDP is enabled in your network and you want the IP
camera to send CDP discovery messages.
Bonjour
Enable Bonjour (Cisco
Discovery Protocol)
Check this check box if Bonjour is enabled in your network and you want the
IP camera to send Bonjour discovery messages.
Bonjour enables the automatic discovery of computers, devices, and services
on and IP network.
HTTP/HTTPS
Enable HTTP
Alternative Port
Check this check box to enable Internet access to the IP camera through an
HTTP port other than the default port 80. If you enable this option, enter a
port number from 1024 through 65535.
If you configure an alternative HTTP port, you must specify the port number
in the URL for the IP camera when you access it through an HTTP
connection. For example, if the IP address of the IP camera is 192.168.1.100
and the alternative HTTP port is 1024, enter this URL for the IP camera:
http://192.168.1.100:1024.
Enable HTTPS
Alternative Port
Check this check box to enable Internet access to the IP camera through an
HTTPS port other than the default port 443. If you enable this option, enter
a port number from 1024 through 65535.
If you configure an alternative HTTPS port, you must specify the port
number in the URL for the IP camera when you access it through an HTTPS
connection. For example, if the IP address of the IP camera is 192.168.1.100
and the alternative HTTPS port is 1024, enter this URL for the IP camera:
https://192.168.1.100:1024.
RTP/RTSP
RTSP Port Transmission Control Protocol (TCP) port on which the IP camera receives
Real-Time Streaming Protocol (RTSP) commands. You must configure this
port to allow third-party devices or software to access video streams from the
IP camera.
RTSP is a standard for connecting a client to control streaming data
(MPEG-4) over the web.
Valid values are 554 and 1024 through 65535. The default value is 554.
RTP Data Port Universal Data Protocol (UDP) port on which the IP camera transmits
Real-Time Transport Protocol (RTP) data.
RTP is a standard for transmitting real-time data, such as audio and video, to
selected clients.
Valid values are 1024 through 65535. The default value is 5000. The default
value can be used for multicasting and typically does not need to be changed.