Filter
Top Products
The Control Panel 137
Setting the alert value for paper
You can configure the printer to alert you when paper is low. Follow the steps
below.
Note:
This setting is available only when you select ROLL or SHEET as your PAPER
COUNTER setting in Maintenance mode.
1. Press Menu to enter the printer’s menu system.
2. Press or to highlight PRINTER SETUP, then press Menu.
3. Press or to highlight ROLL COUNTER or SHEET COUNTER (depending on
which setting you selected in Maintenance mode), then press Menu.
4. Press or to select the length of the roll paper (between 15 and 300 ft
or 5 and 99.5 m) or the number of cut sheets (between 10 and 250) loaded
in the printer, then press Menu.
5. The screen changes so that you can select the alert value. Press or
to select the alert value. For roll paper, select a value between 3 and 50 ft
or 1 and 15 m. For cut sheet paper, select a value between 5 and 50.
6. Press Menu to set the alert value, then press pause to return to the
READY state.
Maintenance Mode
Maintenance mode setting procedure
This section describes how to enter Maintenance mode and how to select
settings with the buttons on the control panel.
Note:
Press to return to the previous step.