Filter
Top Products
&RQWURO3DQHO
3UREOHPV
7URXEOHVKRRWLQJ3ULQWHU3UREOHPV
&RQWURO3DQHO3UREOHPV
'DWD,Q GLFDWRU6WD \V/LW
If the printer has warmed up and the Data indicator stays on, two
problems may exist:
If you are downloading additional typefaces, too many can over-
load the printer’s memory, causing the printer to reset and lose
information previously downloaded to RAM. Make sure you have
enough printer memory.
On a LocalTalk network, Macintosh computers sometimes inter-
fere with each other. If this happens often, reinstall the Laser-
Writer and Laser Prep files, which reset the printer. If neither of
these is the problem, place a service call to your QMS vendor.
1R$G YDQFHG6W DWX V3DJH¶
If your printer prints a standard status page even though you’ve con-
figured the printer in the Administration/Special Pages/Status Page
Type menu to print an advanced status page, your printer probably
doesn’t have enough free memory available. To print an advanced
status page you may need to reduce the amount of memory assigned
to one or more of the memory clients or add more memory (see the
“Memory” section in chapter 5, “Additional Technical Information,” of
the
Reference
guide for information about memory clients).
1R6WDUWX S3 DJH
If the Ready indicator is on, but no start-up page prints, check the fol-
lowing:
1 Has the start-up page been disabled?
Use the control panel to make sure the start-up page is on.