Konica Minolta DiMAGE_A2 Digital Camera User Manual


 
57
Use the front control dial to decrease the shutter-speed until “bulb”
is displayed.
Use the rear control dial to set the appropriate aperture required for
the exposure.
To take the picture, press and hold the shutter-release button for
the duration of the exposure. Releasing the shutter button will end
the exposure.
The monitors will be blank during the exposure. The shutter sound
effect will signal the end of the exposure. The monitors will remain
blank for up to 30 seconds while noise-reduction processing is
applied to the image.
Bulb photographs can be taken in the manual-exposure mode (M). The maximum exposure time
depends on the camera sensitivity setting, see page 55. The use of a tripod and a remote cord is
recommended for bulb exposures. The camera’s exposure system cannot be used to calculate bulb
exposures. The use of a separate light meter is recommended.
Bulb Exposures
Attaching a Remote Cord (sold separately)
The optional remote cords (RC-1000S or RC-1000L) can be used to
reduce vibrations from touching the camera during long exposures.
Before using the cord, attach the ferrite core supplied with the camera
as described on page 167.
Remove the remote-control terminal cover using the notch on the
right side of the cover. The cover is attached to the body to prevent
loss. Insert the plug of the cord into the terminal.