Konica Minolta DiMAGE_A2 Digital Camera User Manual


 
75
Flash Range and Camera Sensitivity
Flash range (wide angle)ISO setting
64
100
200 / AUTO
400
800
0.5m ~ 2.1m / 1.6 ft. ~ 6.9 ft.
Flash range (telephoto)
0.5m ~ 1.7m / 1.6 ft. ~ 5.6 ft.
0.5m ~ 2.7m / 1.6 ft. ~ 8.8 ft.
0.5m ~ 3.8m / 1.6 ft. ~ 12.5 ft.
0.5m ~ 5.4m / 1.6 ft. ~ 17.6 ft.
0.5m ~ 7.6m / 1.6 ft. ~ 25 ft.
0.5m ~ 2.1m / 1.6 ft. ~ 6.9 ft.
0.5m ~ 3.0m / 1.6 ft. ~ 9.8 ft.
0.5m ~ 4.2m / 1.6 ft. ~ 13.8 ft.
0.5m ~ 6.0m / 1.6 ft. ~ 19.6 ft.
For correct flash exposures, the subject must be within the flash range. The flash range can be
extended by changing the camera sensitivity. When the camera sensitivity is set to auto, the ISO is
set between ISO 64 and 200.
The flash range is measured from the CCD. Because of the optical system, the flash range is not
the same at the lens’ wide-angle position as it is at the telephoto position.
To extend the versatility of the camera, an accessory flash unit (sold separately) can be used.
Always remove the accessory flash when the camera is not in use, and replace the accessory-shoe
cap to protect the contacts.
Attaching an Accessory Flash Unit
Slide the accessory-shoe cap off as shown. Mount the
flash unit on the accessory shoe by sliding it forward
until it stops.
The following flash units are compatible with this camera:
Maxxum/Program Flash 2500(D)
Maxxum/Program Flash 3600HS(D)
Maxxum/Program Flash 5600HS(D)
Macro Ring Flash 1200 with Macro Flash Controller
Macro Twin Flash 2400 with Macro Flash Controller
System Accessories