Filter
Top Products
187
Problem Solution Page
Problem Solution Page
➞ 86
➞ 79
➞ 78
➞ 80
➞ 44
➞ 78
➞ 80
➞ 36
Is the flash mark displayed in the control
panel?
Is there strong light in the picture?
Was there something dark in the center of
the picture?
When the flash mark is displayed, the flash
will fire if the camera is in the fill-in flash mode,
even on a well lighted subject. Switch off the
flash mark, or close the built-in flash.
Adjust the exposure compensation or remove
the source of light from the picture.
If the center of the picture was dark, the
overall picture may appear too bright
whatever metering method you use. Try
switching to or center weighted
averaging metering , or you could use
spot metering by centering the subject
under the spot metering mark and then using
AE lock to achieve the correct exposure and
then take the shot.
Is the flash mark blinking in the
viewfinder?
Was the center of the subject very bright?
If the flash mark is blinking, this is a
warning that the subject is too dark and you
should use the flash. Use the flash.
If the center of the picture was very bright,
the overall picture may appear too dark
whatever metering method you use. Try
switching to or center weighted
averaging metering , or you could use
spot metering by centering the subject
under the spot metering mark and then using
AE lock to achieve the correct exposure and
then take the shot.
Pictures are too bright.
Picture is too dark.
Was part of the strap or one of your fingers
blocking the lens?
Make sure nothing blocks the lens when you
compose the picture.
Part of the picture is missing.
Problem Solution Page