Filter
Top Products
Operating Instructions
105
How to
authenticate
The authentication method can be selected:
[No authentication], [POP before SMTP authentication] or
[SMTP authentication].
POP server authentication may be required by your ISP. In
that case, set POP before SMTP authentication.
• No authentication: No authentication when sending an e-
mail.
• POP before SMTP authentication: Some SMTP servers
that send e-mails do not have an authentication feature.
Therefore, the camera uses the authentication of a POP
server that receives e-mails, before sending e-mails.
– POP3 Server IP
Address or Host
Name
*1
:
If you set a server IP address, set
4 numbers (0—255) and 3
periods, such as "192.168.0.253".
Note that "0.0.0.0" and
"255.255.255.255" are not
available. Or set a host name (0—
255 characters).
You can set an IPv6 address.
– Port No.: Enter a number (1—65535).
Usually set to 110.
– Login ID
*2
:
If your ISP requires a login ID to
log in to a POP3 server, set it (1—
63 characters).
–Password
*2
:
If your ISP requires a password to
log in to a POP3 server, set it (0—
63 characters).
• SMTP authentication: Users are authenticated by user
name and password on the SMTP server. Your ISP must
support the SMTP authentication. The supported SMTP
authentications of the camera are the LOGIN and PLAIN
authentications.
– Login ID
*2
:
If your ISP requires a login ID to
log in to an SMTP server, set it
(1—63 characters).
–Password
*2
:
If your ISP requires a password to
log in to an SMTP server, set it
(0—63 characters).
*1 Note that [Space], ["], ['], [&], [<] and [>] are not available.
*2 Note that ["] is not available.
Setting Description