Filter
Top Products
Operating Instructions
123
8. Select the transfer method, and click [Next>].
• Clicking [<Back] takes you back to the previous page.
• Clicking [Cancel] takes you back to the Trigger page without saving
changes.
Note
• If you transfer images by E-mail or FTP, confirm that the default gateway
and DNS server addresses are assigned correctly (see page 48 or page
53).
Enable Post-trigger
Image Buffer
• Check the box to enable the setting. The camera
buffers or transfers the image right after the motion
detection signal is detected.
• Set an interval, number of images to buffer and total
number. The number of buffered images may not
match the total number (see page 191) due to memory
capacity, image resolution, image quality or what object
you view.
Setting Description
No Transfer, No
Memory Overwrite
• If the internal memory or the SD memory card is full,
the camera stops buffering.
No Transfer,
Memory Overwrite
• If the internal memory or the SD memory card is full,
the camera deletes the old images, and continues to
buffer the image.
FTP • The camera transfers the image to an FTP server (see
page 124).
E-mail • The camera transfers the image by E-mail (see
page 126).
Setting Description