Filter
Top Products
Operating Instructions
60
2.5 Encrypting the Camera Image in Transport
Mode
The camera can encrypt images using IPsec transport mode.
Note
• If you use IPsec, the refresh interval increases.
1. Click [IPsec] on the Setup page.
2. Click Camera in the Transport column.
• If you use transport mode for E-mail or FTP transfer, click No. in the Buffer/
Transfer column.
Note
• To display an Alarm Log, set Alarm 1, Alarm 2 or Motion Detection for the
Trigger Setting and check [Enable].
3. Enter each parameter in the relevant data field.
Set to use
Alarm Log.
(See page
137)
The display shows
that the
communication is
in HTTP and
anyone can
access the
camera if they
have the pre-
shared key.
Set up these settings to transfer images in transport mode (see page 131).