Filter
Top Products
Operating Instructions
108
4. Set the time, and click [Next>].
• Clicking [<Back] takes you back to the previous page.
• Clicking [Cancel] takes you back to the Trigger page without saving
changes.
Note
• The timer works by an internal clock. Set the date and time before using
timer buffer/transfer (see page 77).
Setting Description
Enable Image
Buffer/Transfer
• Check the box to enable the buffer/transfer. Uncheck the
box to disable it.
Trigger • Selecting [Timer] enables the camera to buffer/transfer
images by timer.
• Selecting [Alarm 1 or 2] enables the camera to buffer/
transfer images by alarm signal.
• Selecting [Motion Detection] enables the camera to buffer/
transfer images when the motion is detected.
Alarm enable
condition
• Select a method of detection for an alarm connected to the
External I/O terminal.
Select [Rising: GND to Open (High).] or [Falling: Open
(High) to GND.]. [Rising: GND to Open (High).] is the state
when GND pin and pin 1 or pin 2 is left open.
[Falling: Open (High) to GND.] is the state when GND pin
and pin 1 or pin 2 are short-circuited. (See page 164)
Setting Description
Day of the week • Check the box to enable the day. Uncheck the box to
disable it.
Active Time of
Trigger
• To set a trigger time, check the time option and set a time
period. Check the [Always] option if you are not specifying
a time period.