Filter
Top Products
Operating Instructions
49
4. Click [Save] when finished.
• The new settings are saved.
• When finished, the following page is displayed.
Note
• The current network settings are shown on the Status page in the
Maintenance section (see page 155).
5. Click [Restart].
• The camera restarts, and the Top page is displayed.
• Checking [Yes] for [Allow Access from the Internet] on [Automatic Setup]
may not display the Top page, because the port number may change. Use
the Setup Program to access the camera.
Note
• If you do not know the camera IP address when setting [Automatic Setup]
or [DHCP Setup], it can be searched for by the Setup Program (see page
180).
DHCP Setup Static Setup
• Clicking [Cancel] takes you back to the previous page without
saving changes.