Filter
Top Products
Operating Instructions
50
• When the camera is restarted, all buffered images in the internal memory
are deleted. The buffered images on the SD memory card are not deleted.
Setting Description
Allow Access from
the Internet
(Automatic Setup
Only)
• The allow Access from the Internet setting
automatically configures the router's Port Forwarding
setting (some routers call it "Address Translation",
"Static IP Masquerade", "Virtual Server" or "Port
Mapping"). To enable Internet access to the camera,
check [Yes]. In this case, the camera automatically
searches for unused port number on your network in
order of 80 and from 50000 to 50050. To disable
Internet access to the camera, check [No].
Network
Configuration from
Setup Program
(Static/DHCP Only)
• To prohibit the Setup Program from changing the
network settings, uncheck the box.
Port Number
(Static/DHCP Only)
• The default port number is 80. When you use multiple
cameras with a router on your network, each camera
must be assigned its own port number (see page 68
"2.7.2 Connecting the Camera to a Router that Does
Not Support UPnP
™
(IPv4 Only)").
– Do not set the following port numbers.
FTP: 20 and 21, Telnet: 23, SMTP: 25, DNS: 53,
POP3: 110, HTTPS: 443, ICQ: 4000 and IRC:
6661—6667.
• Enter a number between 1—65535.
• Some ISPs do not allow you to use port 80. Ask your
ISP or network administrator about which port
numbers are accessible over the Internet.
• IP address
• Subnet Mask
(Static Only)
• If your ISP or network administrator specifies an IP
address and subnet mask, enter them in each data
field.
• If you use the camera on a LAN, set an IP address with
the same class as your PC (see page 179).
• Set 4 numbers (0—255) and 3 periods, such as
"192.168.0.253". Note that "0.0.0.0" and
"255.255.255.255" are not available.