Filter
Top Products
27
VQT1H62
Setup
Inserting/removing the battery
1 While sliding the SD CARD/
BATTERY OPEN lever A, move
the SD card/battery cover and
open it.
2 Insert the battery until it clicks
while paying attention to the
direction of the battery.
B Push the center of the battery until it locks.
3 Close the SD card/battery cover.
≥ Securely close it until it clicks.
1 Open the SD card/battery cover.
2 Remove the battery.
≥ Move A in the direction of the arrow to unlock
it and then remove the battery.
3 Close the SD card/battery cover.
≥ Be sure to set the mode dial to OFF and check
that the status indicator is off before removing
the battery.
≥ The SD card/battery cover opens up to 180o.
Inserting the battery
A
1
2
B
Removing the battery
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
A
VQT1H62_ENG_PP.book 27 ページ ２００７年７月１７日 火曜日 午後５時４４分