Filter
Top Products
39
VQT1H62
Setup
3 Press the MENU button to exit
the menu screen.
Setting date and time
When the unit is turned on for the first time, a
message asking you to set the date and time will
appear.
≥ Move the cursor button up or down to select
[YES], press the cursor button and then
perform steps 2 and 3 below to set the date
and time.
If the screen shows the incorrect date and time,
then adjust it.
¬Rotate the mode dial to select .
1 Press the MENU button, then
select [BASIC] # [CLOCK SET]
# [YES] and press the cursor
button.
2 Move the cursor button left or
right to select the item to be set.
Then, move the cursor button up
or down to set the desired value.
≥ The year will change as follows:
2000, 2001, ..., 2039, 2000, ...
≥ The 12-hour system is used to display the time.
3 Press the cursor button to enter
the selection.
≥ The clock function starts at [00] seconds when
the cursor button is pressed.
≥ Press the MENU button to finish the setting.
Check the date and time displayed.
Changing the date and time display style
Press the MENU button, then select [SETUP] #
[DATE/TIME] # desired display style and press
the cursor button.
≥ You can also show or change the date and
time display by repeatedly pressing the DATE/
TIME button on the remote control.
Changing the display style
Press the MENU button, then select [SETUP] #
[DATE FORMAT] # desired display style and
press the cursor button.
≥ The date and time function are driven by a
built-in lithium battery.
≥ Make sure to check the time before recording.
≥ If the time display becomes [- -], the built-in
lithium battery has run down. Use the following
steps to charge the battery.
To recharge the built-in lithium battery:
If you connect the AC adaptor or insert the
battery in this unit, the built-in lithium battery will
be recharged. Leave the unit as it is for approx.
24 hours and the battery will save the date and
time for approx. 6 months. (The battery is still
being recharged even if the mode dial is set to
OFF.)
When you turn on the power for the first time
after charging, a message asking you to set the
MENU
ENTER
[DATE] [D/T]
[OFF]
Display style Screen display
[Y/M/D] 2008. 1. 1
[M/D/Y] JAN 1 2008
[D/M/Y] 1. 1. 2008
JAN 1 2008 12:34PMJAN 1 2008
VQT1H62_ENG_PP.book 39 ページ ２００７年７月１７日 火曜日 午後５時４４分