Filter
Top Products
Before Use
-10-
Quick Guide
1 Attach the Battery to the AC Adaptor and
charge it.
≥Before use, fully charge the Battery.
≥Since the Battery will not be charged when
the DC Cable is connected to the AC
Adaptor, disconnect it from the AC Adaptor.
≥The [CHARGE] Lamp lights up, and charging
starts.
≥When the [CHARGE] Lamp goes off,
charging is completed.
2 Attach the charged Battery to the
Camcorder.
ª Inserting a Cassette
1 Slide the [OPEN/EJECT] Lever 1 toward
the front and pull down to open the
Cassette Compartment Cover.
2 Insert a Cassette.
3 Close the Cassette Holder by pressing the
[PUSH] mark 2.
4 Close the Cassette Compartment Cover.
1
OPEN/
EJECT
PUSH
2
ª Inserting a Card
1 Slide the [OPEN] Lever 1 to open the Card
Slot Cover 2.
2 While holding the Memory Card with its cut
corner on top 3, insert it into the Card Slot.
3 Close the Card Slot Cover 2 securely.
ª Recording on a Tape
1 Set the [OFF/ON] Switch 1 to [ON].
≥The [POWER] Lamp 2 lights up.
2 Set the Mode Dial to Tape Recording Mode.
3 Press the Recording Start/Stop Button.
≥Recording starts.
4 Press the Recording Start/Stop Button
again to pause the recording.
1
2
OPEN
3
POWER
1
2
ON
OFF
PC
S
D
PV-GS120_200Eng.book 10 ページ ２００４年２月１６日 月曜日 午後１時３２分