Filter
Top Products
With a PC
-64-
For Macintosh
1 Turn on Computer and start up Macintosh.
2 Insert supplied CD-ROM into the CD-ROM
drive.
3 Double click the CD-ROM icon that appears.
4 Double click [ArcSoft].
5 Double click [PhotoImpression] (or
[PhotoBase] or [PanoramaMaker] or
[PhotoPrinter]).
6 Double click [English] or [French].
7 Double click [PhotoImpression Installer] (or
[PhotoBase Installer] or
[PanoramaMaker Installer] or
[PhotoPrinter Installer]).
8 Follow the instructions on the computer
screen until the installation is complete.
ª To start software in ArcSoft Software
Suite
1
Select [Start] >> [All Programs (Programs)]
>> [ArcSoft Software Suite] >>
[Panorama Maker 3] (or [PhotoBase 4] or
[PhotoImpression 4] or [PhotoPrinter 4]).
Refer to Help information about application
operations and other Error messages.
For Information on ArcSoft Software:
TEL: 1-510-440-9901
Web Site: www.arcsoft.com
To disconnect USB cable safely
If USB cable is disconnected while computer is
on, error dialog box may appear. In such a case
click [OK] and close the dialog box. By following
the steps below you can disconnect the cable
safely.
1 Double click the icon in task tray.
≥Hardware disconnect dialog box appears.
2 Select [USB Mass Storage Device] and click
[Stop].
3 Verify [Matshita DVC USB Device] is
selected and click [OK].
≥You can safely disconnect the cable.
Note on the driver name displayed
The driver name displayed will differ depending
on your OS, operating environment and the mode
of the Camcorder.
Windows XP/2000:
(When the Camcorder is in Tape Recording mode
or Tape Playback Mode:)
[Panasonic DVC USB-SERIAL Driver for Win XX
(COM X)] (The numeral designation after “Win”
will differ depending on the OS. The numeral after
“COM” will differ depending on the operating
environment of your personal computer.)
(When the Camcorder is in PC Mode:)
[USB Mass Storage Device] or
[Panasonic DV DISK Port Driver]
Windows Me:
(When the Camcorder is in PC Mode:)
[USB Disk]
≥Some Operating Systems, such as Windows
98SE, may not show the icon indicating that you
may safely disconnect in task tray. (OS may be
set not to show.) Make sure Camcorder’s Card
Access Lamp is off and disconnect the cable.
Also, with Windows Me, the icon will not be
displayed when in Tape Recording Mode or
Tape Playback Mode.
CAUTION:
If you disconnect the USB Cable while the
Card Access Lamp is on, it may damage the
Card data.
PV-GS120_200Eng.book 64 ページ ２００４年２月１６日 月曜日 午後１時３２分