Panasonic PV-GS120 Camcorder User Manual


 
Playback Mode
-42-
Playback Mode
Playing Back a Tape
The recorded scene can be played back
immediately after the recording.
1 Set the [OFF/ON] Switch (43) to [ON].
The [POWER] Lamp
(41) lights up.
2 Set the Mode Dial (39) to Tape Playback
Mode.
3 Press the [6] Button (19) to rewind the
tape.
Rewind the tape to the point where you want
to start playback.
When the tape reaches the beginning,
rewinding stops automatically.
4 Press the [1] Button (17) to start playback.
The [!] Indication appears.
If a cassette recorded with a copyright
protection signal is played back, the picture is
distorted by mosaic-like patterns.
To Stop Playback
Press the [] Button (18).
ON
OFF
POWER
(41)
(43)
PC
S
D
(39)
ENTER
FADE
STILL
is
(19)
FADE
STILL
ENTER
is
(17)
(18)
ENTER
FADE
STILL
is
ª Adjusting the Sound Volume
To adjust the volume, push the [`VOL/JOG_]
Lever
(46) to display the [VOLUME] Indication.
Push the [`VOL/JOG_] Lever towards [T] to
increase the volume or push the [`VOL/JOG_]
Lever towards [W] to decrease the volume. The
[VOLUME] Indication goes off after the
adjustment is finished.
To adjust the volume with the Remote Controller,
press the [T] or [W] Button to display the
[VOLUME] Indication. Press the [T] Button to
increase the volume or press the [W] Button to
decrease the volume. The [VOLUME] Indication
goes off after the adjustment is finished.
The sound volume cannot be adjusted using the
Remote Controller in Playback Zoom Mode.
(
-44-)
For other notes concerning this item, see
-75-.
Finding a Scene You Want to Play
Back
ª Cue/Review Playback
If the [5] Button (16) or [6] Button (19) is
pressed during Playback, it turns to Cue Playback
A or Review Playback B.
If the Button is held continuously, it turns to Cue
Playback or Review Playback until you release
it.
VOL/JOG
WT
(46)
ENTER
FADE
STILL
is
(19) (16)
A
B
PV-GS120_200Eng.book 42 ページ 2004年2月16日 月曜日 午後1時32分