Filter
Top Products
C611M-C (3/06) 21
CONFIGURING TCP/IP SETTINGS
To configure TCP/IP settings, do the following:
1. Click the NVR300 Platform Admin icon to call up the NVR300 Platform Administrator screen.
2. On the NVR300 Platform Administrator screen, click the Network Settings button.
3. Double-click Local Area Connection.
4. Click Properties. The Local Area Connection Properties dialog box appears.
5. In the box listing the items used by the connection, double-click Internet Protocol (TCP/IP). The Internet Protocol (TCP/IP) Properties
dialog box appears.
The “Obtain an IP address automatically” and “Obtain DNS server address automatically” radio buttons are selected by default.
6. Do either of the following:
• If your network supports the capability to obtain an IP address and DNS server address automatically, proceed to step 7.
• If your network does not support this capability, click the Use the following IP address radio button and then do the following:
a. Enter the IP address of the NVR300.
b. Enter the subnet mask address.
c. If applicable, enter the default gateway address.
d. In the Use the following DNS server addresses box, enter the preferred and alternate DNS server addresses if applicable;
otherwise, skip this step and proceed to step 7.
7. Click the OK button. The Local Area Connection Properties dialog box appears.
8. Click the OK button.
9. Close the Network Connections window by clicking the X in the upper right corner of the window.
CONFIGURING E-MAIL ALERT FOR AN INTERNAL RAID NVR300
NOTE: The following information applies to NVR300 internal RAID models only; and not to non-RAID models.
If a hard disk drive fails or a communication error occurs within an internal RAID configuration, the NVR300 has three types of notification to alert
you of the failure or problem:
1. If an e-mail server is configured, an e-mail containing a text message describing the error is sent to the designated e-mail address.
2. A pop-up message box indicating the error appears on the monitor connected locally to the NVR300.
3. Errors and notifications are recorded to a log file. The log file is available for viewing when needed. The log file can be accessed by clicking
the Watchdog Email Setup button on the NVR300 Platform Administrator screen.
4. Fill in the Mail/To address (for example, JDoe@Company.com).
5. Fill in the Mail Server (for example, 192.162.0.11).
6. File in the Mail From address (for example, NVR300@Pelco-NVR300one).