Filter
Top Products
C611M-C (3/06) 35
LOGGING IN TO THE NVR300
If you are required to log in to the NVR300, you must enter a user name and password. Before performing the procedure below, contact your
system administrator for user name and password information.
To log in to the NVR300, do the following:
1. Access the NVR300 (refer to the Accessing the NVR300 User Interface section for access information).
A dialog box appears, allowing you to enter a user name and password (refer to Figure 25).
Figure 25. User Name and Password Dialog Box
2. In the “User name” text entry box, enter one of the following user names assigned to you by the system administrator: user or service.
NOTE: The user name is case sensitive and must be entered using lowercase letters.
3. In the Password text entry box, enter the password assigned to the user name. The password can contain up to 19 alphanumeric characters
and is case sensitive.
4. If desired, select the “Remember my password” check box to avoid the need to reenter your password each time you log in to the NVR300.
NOTE: The check box is a toggle and is selected and deselected by clicking the box. The check box is selected when a checkmark appears in
the box.
5. Click the OK button.
The NVR-Playback page of the NVR300 appears if accessing the NVR300 from a VMX300 or client PC. The NVR-Status page appears if
accessing the NVR300 locally.
You can now begin operation of the NVR300. (For information about the user access privileges associated with your user name, refer to Table D.)