Pentax 15613 Digital Camera User Manual


 
146
Shooting Settings
5
5
Use the four-way controller (2345) to move the frame
to the position you want to measure.
6
Press the 4 button.
The white balance is measured, and the screen that was displayed in
Step 2 appears again.
Adjust the white balance as necessary.
The message [The operation could not be completed correctly] appears
when measuring is unsuccessful. Press the 4 button to remeasure the
white balance.
7
Press the 4 button.
The camera is ready to take a picture.
You can copy the white balance settings of a captured image and save it
as Manual White Balance.
1
Press the four-way controller (3) in the single image display
of playback mode.
The playback mode palette appears.
2
Use the four-way controller (2345) to select K (Save
as Manual WB), and press the 4 button.
The save confirmation screen appears.
3
Turn the front e-dial (R) to select an image.
If a picture is extremely overexposed or underexposed, the white balance may
not be adjusted. In this case, adjust exposure to the correct exposure before
adjusting the white balance.
Saving the White Balance Settings of a Captured Image
Only the white balance settings of still pictures taken with this camera can be
copied. However, the following images cannot be selected.
Multi-exposure image
Index image
Still pictures captured from a movie
e_kb524_84percent.book Page 146 Friday, June 15, 2012 12:13 PM