Filter
Top Products
95
Shooting Functions
4
Choose the part of the sensor to use for measuring brightness and
determining exposure.
1
Press the M button in standby mode.
The control panel appears.
2
Use the four-way controller (2345) to select [AE Metering],
and press the 4 button.
The [AE Metering] screen appears.
3
Use the four-way controller (45)
to select a metering method, and
press the 4 button.
The camera returns to the control panel.
Selecting the Metering Method
L
Multi-
segment
The sensor meters the brightness in multiple zones. (default setting)
Even in backlit locations, this mode automatically determines what level
of brightness is in which portion and automatically adjusts exposure.
M
Center-
weighted
Metering is weighted at the center of the sensor.
The sensitivity increases at the center and no automatic
adjustment is performed even during backlit scenes.
N Spot
The brightness is measured only within a limited area at the center
of the sensor. You can use this in combination with AE Lock (p.94)
when a subject is too small to obtain a correct exposure.
• You can also change the setting from the [A Rec. Mode 1] menu.
• Exposure metering is performed immediately after the camera is turned on or
when the capture mode is changed. Set the length of meter operating time in
[4. Meter Operating Time] of the [A Custom Setting 1] menu. Select from
[10sec.] (default setting), [3sec.] or [30sec.].
• In [6. Link AE and AF Point] of the [A Custom Setting 1] menu, you can link
the exposure and AF point in the focusing area when L is selected.
AE Metering
AE Metering
Multi-segment
Multi-segment
OK
OK
OK
Cancel
Cancel
MENU
Off
Exposure for multi-segment metering is determined regardless of
the AF point. (default setting)
On
Exposure for multi-segment metering is adjusted according to the AF point.
e_kb524_84percent.book Page 95 Friday, June 15, 2012 12:13 PM