Pentax K-m/K2000 Digital Camera User Manual


 
2
Caution
Do not short the batteries or dispose of the batteries in fire. Do not
disassemble the batteries. The batteries could explode or catch fire.
Of the batteries that can be used in this camera (AA Ni-MH batteries, AA
lithium batteries and AA alkaline batteries), only the Ni-MH batteries can be
recharged. Recharging other batteries can cause a fire or explosion.
Remove the batteries from the camera immediately if they become hot or
begin to smoke. Be careful not to burn yourself during removal.
Some portions of the camera heat up during use. There is the risk of low
temperature burns when holding such portions for long periods.
Do not place your finger over or cover the flash with clothing when
discharging the flash. Fingers or clothing may be burned.
To reduce the risk of hazards, use only CSA/UL Certified power supply cord
set, cord is Type SPT-2 or heavier, minimum NO.18 AWG copper, one end
with a molded-on male attachment plug cap (with a specified NEMA
configuration), and the other is provided with a molded-on female connector
body (with a specified IEC nonindustrial type configuration) or the equivalent.
Only use the specified batteries with this camera. Use of other batteries can
cause a fire or explosion.
Replace all the batteries at the same time. Do not mix battery brands, type
or an old battery with a new one. It may cause explosion or a fire.
The batteries should be inserted correctly with regard to polarity (+ and –)
marked on the batteries and the camera. Not inserting batteries correctly
may cause explosion or a fire.
Do not disassemble the batteries. Of the batteries that can be used in this
camera, only the AA Ni-MH batteries can be recharged. Disassembling the
batteries or attempting to charge non-rechargeable batteries could result in
explosion or leakage.
When traveling, take the Worldwide Service Network that is included in the
package. This will be useful if you experience problems abroad.
PRECAUTIONS FOR BATTERY USAGE
Care to be Taken During Handling