Filter
Top Products
• If you are using a plug-in compatible application, pull down
the File menu, choose Acquire, and choose PDC-2000.
Note: If no pictures are stored in the camera, the Take
Pictures window appears instead of the Transfer Pictures
window.
3 Click the Set Preferences button to display the Set Preferences
window.
4 Click the Release Camera button, then click Yes to release the
camera and return to the image-processing application or exit
from PDC-2000 Direct.
After releasing the camera, refer to Chapter 3 for camera
operating instructions.
WARNING: DO NOT TURN OFF THE CAMERA OR
DISCONNECT IT FROM THE COMPUTER AFTER IT
HAS BEEN RELEASED FROM COMPUTER CONTROL.
DOING SO COULD DAMAGE YOUR COMPUTER OR
CORRUPT DATA ON YOUR HARD DISK.
If you want to turn off the camera while its cable is connected
to the computer, use the procedure recommended for any
SCSI device: (1) turn off the computer, and (2) turn off the
camera. To disconnect the camera from the computer, see
Disconnecting the camera from your computer on page 29.
Restoring computer
control
After releasing the camera from computer control as
described above, you can place the camera back under
computer control at any time with these steps:
1 Start your TWAIN compliant or plug-in compatible
application, or start PDC-2000 Direct.
2 If you are using PDC-2000 Direct, wait for the Transfer
Pictures window to appear.
Using the PDC-2000 with your PC 103