Filter
Top Products
Troubleshooting error messages
When necessary, the PDC-2000 camera displays error
messages on the LCD panel to inform you about operating or
hardware problems. The list below recommends specific
action for each error message.
Error messages not listed below may also appear on the LCD
panel. If an unlisted message appears, turn the camera off
briefly, then turn it back on. If the message reappears, contact
Polaroid Technical Assistance (see page 115).
WARNING: WHEN THE INSTRUCTIONS BELOW
DIRECT YOU TO TURN THE CAMERA OFF AND BACK
ON, TURN OFF THE COMPUTER BEFORE DOING SO
(IF THE CAMERA IS CONNECTED TO YOUR
COMPUTER). FAILURE TO TURN OFF THE COMPUTER
COULD CORRUPT DATA ON YOUR HARD DISK,
DAMAGE THE CAMERA, OR DAMAGE THE
COMPUTER.
charging The camera is not ready to take flash pictures
because the electronic flash is still charging. Wait until the
yellow indicator in the viewfinder goes out before trying
again.
disk full The camera has reached its storage capacity.
Transfer the pictures to your computer (page 69 for
Macintosh and page 91 for PC), and erase the pictures from
the camera (page 71 for Macintosh and page 93 for PC).
error 01h The camera detected a problem with its picture
storage hardware. Turn the camera off briefly, then turn it
back on. If the message reappears, contact Polaroid Technical
Assistance (see page 115). When this condition exists, you can
still take pictures by operating the camera under computer
control (page 72 for Macintosh and page 94 for PC) but you
will not be able to store additional pictures in the camera or
transfer pictures previously stored in the camera.
Maintenance and troubleshooting 111