Filter
Top Products
After verifying the camera’s internal settings, proceed as
follows:
If you intend to take pictures with the camera disconnected
from the computer, close your image-processing application
or PDC-2000 Direct by choosing Quit from the File menu.
Then turn off the computer and the camera, and disconnect
the camera as described on page 29. Refer to Using the
PDC-2000 camera on page 33 for picture-taking instructions.
If you will take pictures while using the computer to control
the camera, leave the camera connected to the computer.
Refer to Using the PDC-2000 with your Macintosh on
page 61.
Connecting the camera to your PC
The PDC-2000 camera is an internally terminated SCSI device
designed to connect to a SCSI adapter on your
IBM-compatible computer. How you connect the PDC-2000
depends on whether you have other SCSI devices connected to
your computer.
Note: Be sure to set the camera’s SCSI ID as described on
page 11 before connecting the camera. Also, your
IBM-compatible computer must have an ASPI-compliant SCSI
adapter for attaching the camera. See System requirements on
page 2 for more information.
Setting up 23