Filter
Top Products
Note: The camera is not operable without the batteries, even
if the power adapter/trickle charger is connected.
Charge the new batteries completely by leaving the charger
connected to the camera for about 12 hours. (After this initial
charging, the batteries will recharge completely in about 6
hours.)
WARNING: USE ONLY THE POWER ADAPTER/
TRICKLE CHARGER PROVIDED FOR CHARGING THE
BATTERIES WHILE THEY ARE IN THE CAMERA.
OTHER ADAPTERS AND CHARGERS SIMILAR IN
APPEARANCE ARE AVAILABLE, BUT THEY CAN
OVERHEAT THE BATTERIES AND CAUSE INJURY OR
CAMERA DAMAGE.
You can also charge the batteries outside the camera with
optional 110-volt 5-hour battery charger (see Optional
accessories on page 9) or another charger compatible with
your local AC voltage and designed for NiCad “AA”
batteries. Carefully follow the instructions provided with the
charger you are using.
Connecting the camera to your Macintosh
The PDC-2000 camera is an internally terminated SCSI device
designed to connect to the SCSI port of your Macintosh
computer. How you connect the PDC-2000 depends on
whether you have other SCSI devices connected to your
computer.
Note: Be sure to set the camera’s SCSI ID as described on
page 11 before connecting the camera.
Setting up 17