Filter
Top Products
• Current time
• Automatic shutoff timeout values
• Camera sound indicator status
Before using the PDC-2000 camera for the first time, verify
(and change, if necessary) these settings by following
instructions in Changing operating preferences on page 97.
After verifying the camera’s internal settings, proceed as
follows:
If you intend to take pictures with the camera disconnected
from the computer, close your image-processing application
by choosing Exit from the File menu. Then turn off the
computer and the camera, and disconnect the camera as
described below. Refer to Using the PDC-2000 camera on
page 33 for picture-taking instructions.
If you wish to take pictures while using the computer to
control the camera, leave the camera connected to the
computer. Refer to Using the PDC-2000 with your PC on
page 83.
Disconnecting the camera from your computer
If you want to take pictures with the PDC-2000 camera away
from the computer, use the following steps to disconnect it.
Note: The procedure below disconnects the camera cable
from the computer. To use the camera controls for taking
pictures without disconnecting the camera from the
computer, see Releasing the camera from computer control
on page 80 (Macintosh) or page 102 (PC) instead.
1 Turn off the computer.
Setting up 29