Filter
Top Products
When you press the Power button, the camera performs a
brief self-test, then displays a normal LCD panel. If the sound
indicators are enabled, the camera also emits a short,
high-pitched tone to indicate that it passed the self-test and is
ready to take pictures.
If the camera detects any problems or errors during its
self-test, it displays an error message on the LCD and emits
one or two short, low-pitched tones. (For more information
about error messages, see Troubleshooting error messages on
page 111.)
Setting to stand-alone
mode
If your PDC-2000 camera is connected to a computer, you
must release it from computer control to operate in the
stand-alone mode.
Use either of these two methods to release it:
• Use the computer to release the camera. (See Releasing the
camera from computer control, page 80 for Macintosh or
page 102 for PC.)
• Disconnect the camera from the computer. (See Disconnecting
the camera from your computer on page 29.)
WARNING: DO NOT DISCONNECT OR CONNECT
ANY DEVICE WHILE THE DEVICE OR YOUR
COMPUTER IS TURNED ON. DOING SO COULD
DAMAGE THE DEVICE, YOUR COMPUTER, OR BOTH.
42