Filter
Top Products
After connecting the SCSI cable, connect the camera to AC
power using the power adapter/trickle charger (c).
IMPORTANT: ALWAYS CONNECT THE CAMERA TO
AC POWER WHEN IT IS CONNECTED TO THE
COMPUTER. IF THE CAMERA OR ANY OTHER SCSI
DEVICE TURNS OFF WHILE CONNECTED, IT COULD
CORRUPT DATA ON YOUR HARD DISK.
If your Macintosh has
other SCSI devices
Because the PDC-2000 camera is internally terminated, you
must install it as the last device in your SCSI chain as follows:
1 Turn off the computer, all SCSI devices, and the camera.
2 Remove the terminator (a) from the last SCSI device in your
SCSI chain.
Note: Keep the terminator. You must reconnect it if you use
the computer while the camera is not attached.
3 Attach the DB25/50 pin Centronics adapter (b) to the end of
the SCSI system cable (c).
Use only the cable provided with the camera. Other cables
may appear similar, but could damage the camera or your
computer.
4 Connect the DB25/50 pin Centronics adapter (b) to the
connector from which you removed the terminator.
Setting up 19