Filter
Top Products
MIRROR UP
70
from the first to the last image capture in the series. The middle shot in the series is the
basis shot that is set (image 1).
When the focus of the original image is already close to the stop position of the
focus (i.e. the minimum or maximum possible focus of the camera), the focus
bracketing cannot be performed in the pre-defined step size, and the position of
the original image may deviate from the set focus.
13 Mirror Up
Using the function “Mirror Up”, the mirror is locked before the shutter is activated. In this
way, any agitation of the camera when capturing the image can be avoided.
Press the button Mirror Up B4 at the hand
grip to lock the mirror, then press the
Release Button B1 to take the image.
By toggling, the mirror is reset to its original
position.
Fig. 13 / 1 Mirror Up
The camera internal exposure measurement is not active when the mirror is
locked, therefore the exposure value is applied that has been measured
immediately before the mirror has been locked up. If the exposure measurement
value has been previously saved using the button AE-Lock B7, this measurement
value will be applied.