Filter
Top Products
79
Using the Menu
MONO
Outputs in monaural.
x INT MIC SENS
You can set recording sensitivity of the
internal microphone.
BNORMAL
Sensitivity that is normally used in
professional recordings.
HIGH
Sensitivity that is normally used in
consumer recordings.
appears on the status check
screen.
x INT MIC WIND
BOFF
Disables wind noise reduction.
ON
Enables wind noise reduction.
appears on the status check screen.
x XLR AGC LINK
You can select either linked or separate
AGC (Auto Gain Control) of CH1 and CH2
when using an external microphone.
BSEPARATE
Separately applies the AGC for CH1/CH2.
Sound inputs from CH1/CH2 will be
recorded as separate sound.
LINKED ( )
Applies the AGC of CH1 linked with that
of CH2. Sound inputs from CH1/CH2 will
be recorded as a set of sound such as stereo
sound. appears on the status check
screen.
b Notes
• This function is available when the CH1 and
CH2 switches are set to AUTO and the INPUT1
and INPUT2 switches are both set to MIC or
both set to LINE (p. 39).
x AUDIO MANUAL GAIN
You can select either linked or separate
audio level control of CH1 and CH2 when
using an external microphone.
BSEPARATE
Separately controls the audio levels of
CH1 and CH2. Sound inputs from CH1
and CH2 will be recorded as separate
sound.
LINKED ( )
Controls the audio level of CH1 linked
with that of CH2. Sound inputs from CH1
and CH2 will be recorded as a set of sound
such as stereo sound. appears on the
status check screen.
b Notes
• This function is available when the CH1 and
CH2 switches are set to MAN and the INPUT1
and INPUT2 switches are both set to MIC or
both set to LINE (p. 39).
• When you select [LINKED], you can adjust the
volume with the AUDIO LEVEL dial of CH1
(p. 39).
x INPUT1 TRIM
You can adjust the input signal level from
INPUT1.
You can select from [-18dB], [-12dB],
[-6dB], [0dB], [+6dB] and [+12dB]. The
default setting is [0dB].
b Notes
• The setting is not effective when you set the
INPUT1 switch to LINE.
x INPUT1 WIND
BOFF
Disables wind noise reduction.
ON
Enables wind noise reduction.
appears on the status check screen.
b Notes
• The setting is not effective when you set the
INPUT1 switch to LINE.
INT MIC SET
XLR SET
A
M
Continued ,