Filter
Top Products
Chapter 4 Adjustments and Settings for Recording 4-57
4
4-8-3 Display Mode and Setting Change and
Adjustment Progress Messages
You can limit or suppress the messages that give details of setting
changes and adjustment progress and results by setting a display mode.
The conditions under which messages are displayed and their
correspondence with the display mode are as follows:
Setting change and adjustment progress messages and display modes
Y : Message is displayed.
N : Message is not displayed.
Message display
condition
Message Display mode
setting
1 2 3
When the filter selection
has been changed
ND : n (where n = 1, 2, 3, 4)
CC : m (where m = A, B, C, D)
When the gain setting
has been changed
GAIN : n dB (where n = −3, 0,
3, 6, 9, 12, 18, 24, 30)
N N Y
N N Y
When the setting of the
WHITE BAL switch has
been changed
WHITE : n (where n = A CH,
B CH, PRST)
N N Y
When the OUTPUT /
DCC selector has been
set to DCC ON or OFF
a)
DCC : ON (or OFF) N Y Y
When the shutter speed
and mode setting has
been changed
b)
: SS : 1/100 (DVW-700) or
1/60 (DVW-700P) (or 1/125,
1/250, 1/500, 1/1000,
1/2000, CLS, ECS, EVS)
N Y Y
When the black or white
balance has been
adjusted
E.g. WHITE : OK
For more informarion, see
Section 4-1 “Adjusting the
Black Balance and the White
Balance” (page 4-1).
N Y Y
a), b) : See the next page.