Filter
Top Products
Chapter 5 Setting Up the Camcorder 5-7
5
2 Mount the DC-L90 Battery Adaptor on the back of the camcorder.
5-1-4 Avoiding Breaks in Operation Due to Dead
Batteries
If you use both an internal battery pack and an external battery connected
to the DC IN connector at the same time, you can avoid breaks in
operation due to the dead batteries.
When the external battery begins to fail and an internal
battery pack is also used
Remove the DC output cable of the external battery from the DC IN
connector. The power source will switch to the internal battery pack.
When the external battery begins to fail and an internal
battery pack is not used
First load the camcorder with a fully charged internal battery pack, then
remove the DC output cable of the external battery from the DC IN
connector. The power source will switch to the internal battery pack. To
use an external battery again, connect a fully charged external battery to
the DC IN connector before unloading the internal battery pack. The
power source will switch to the external battery.
Back of camcorder