Filter
Top Products
4-90 Chapter 4 Adjustments and Settings for Recording
4
6 To end writing the ID, press the UP button; to return and correct the
ID, press the DOWN button.
If you press the UP button, the message disappears.
If you press the DOWN button, the message disappears and the
cursor reappears above the left-most character of the card ID (return
to the status of step 2). If a correction is necessary after you press
the UP button, press the UP button again to re-display the cursor
above the card ID and enable correction (return to the status of step
2).
Note
The camera ID is always read and written with other data. Therefore, if
the camera ID is written to a card after being set or modified through the
SETUP CARD page for data stored in the camera, data other than the
camera ID will also be written onto the card. To set or modify only the
card ID of data stored on a card, read the data from the card to the
camcorder, set or modify the card ID, then write that data back to the
card.