Filter
Top Products
4-10 Chapter 4 Adjustments and Settings for Recording
4
If automatic white balance adjustment cannot be made
If the white balance adjustment cannot be completed normally, an error
message will appear for about 3 seconds on the viewfinder screen (in
display mode 2 or 3).
Possible messages are listed below.
White balance adjustment error messages
Error message
WHITE : NG
LEVEL TOO LOW
WHITE : NG
COLOR TEMP. HIGH
WHITE : NG
COLOR TEMP. LOW
WHITE : NG
TIME LIMIT
Meaning
The white video level is too low. Either make the
lighting brighter or increase the gain.
The color temperature is too high. Select a
suitable filter setting.
The color temperature is too low. Select a
suitable filter setting.
Adjustment could not be completed within the
standard number of attempts.
WHITE : NG
POOR WHITE AREA
WHITE : NG
LEVEL TOO HIGH
The white area could not be checked.
The white video level is too high. Either narrow
the lens iris opening or change the ND filter.
If any of the above error messages is displayed, retry the white balance
adjustment. If the error message occurs again, an internal check is
necessary.
Refer to the Maintenance Manual for information about this internal check.
Note
The white balance cannot be adjusted while the setup menu is displayed
on the viewfinder screen. Always set the MENU ON / OFF / PAGE
switch to OFF before starting these adjustments.