Filter
Top Products
Chapter 4 Adjustments and Settings for Recording 4-11
4
If you have no time to adjust the white balance
Set the WHITE BAL switch to PRST. A white balance for each of the
CC filter is automatically taken to correspond to the setting of the outer
FILTER ring.
White balance memory
Values stored in memory are saved for about one week when the
camcorder is turned off.
There are two sets of white balance memories, A and B, and adjustments
for each of the filters can be automatically stored in the memory
corresponding to the setting (A or B) of the WHITE BAL switch. The
camcorder has four built-in filters, so a total of eight (4 × 2) adjustments
can be stored. The number of memories allocated each A and B can be
limited to one each by setting FILTER INH. to ON on the FUNCTION
2 / 2 page of the setup menu. In this case, the memory contents are not
linked to the filters.
If a memory error occurs
If the error message “: MEMORY : NG” flashes on the viewfinder
screen for about 3 seconds when the camcorder is turned on, the white
balance memory content has been lost.
Adjust the black balance and the white balance again. Contact your Sony
representative if this message continues to appear even after the black
balance and the white balance have been adjusted again.
For more information, refer to the Maintenance Manual.