Filter
Top Products
5
Chapter 5 Setting Up the Camcorder5-36
Settings of the absolute value volume controls
1)
and absolute value
switches
2)
are overwritten by those on the remote control unit after the
remote control unit is connected.
When the remote control unit is removed from the camcorder, the
independent data region becomes effective. Thus the camcorder will
return to the settings that were in effect before the remote control unit
was connected.
When RM COMMON MEMORY is set to ON on the FUNCTION 3
page of the MAINTENANCE menu, you can use settings of the paint
adjustment data stored in the independent data region even if you
connect the remote control unit. In this case, the settings stored in the
independent data region will be renewed when you change the settings
on the remote control unit. Thus, the settings of the paint data made with
the remote control unit can be retained even if the remote control unit is
removed. However, if the switch position on the remote control unit
differs from the one on the camcorder, the switch position on the
camcorder takes precedence over that on the remote control unit.
Also, it is possible to keep the settings that are in effect before you
connect the remote control unit. In this case, you should set the volume
to the relative mode on the remote control unit.
For details, refer to the instruction manual supplied with the RM-B150.
....................................................................................................................................
1) Absolute value volume control
The data corresponding to the rotation degree (position) of the volume controls
is output. The data corresponding to the rotation amount is called the relative
value volume
2) Absolute value switch
Like the toggle switches or slide switches (except the momentary switches), the
switches (or controls) whose positions must coincide with their functions are
called absolute value switches.