Filter
Top Products
2
Chapter 2 Locations and Functions of Parts and Controls 2-41
H MIN SEC FRM
40
PEAK dB
OVER
EMPH
OVER
TAPE E B
V
H
HOLDPB VITC NDF EXT-LK
RF SERVO HUMID SLACK
BATT E F
30
10
0
20
TAPE E B
BATT E F
2-8 Warnings and Indications
on the Display Panel
Tape status, battery status, and level indicators
Tape status, battery status, and level indicators
Audio channel level meter: When the CH-1/2 / CH-3/4 switch is
set to CH-1/2, the audio channel level 1 is displayed.
When the CH-1/2 / CH-3/4 switch is set to CH-3/4, the audio
channel level 3 is displayed.
Battery status indicator
Fully charged
Nearly dead: “BATT” flashes.
Dead battery (battery must be charged):
“BATT” and “E” flash.
Tape status indicator
Full (at beginning)
Close to end: “TAPE” flashes.
End (tape must be replaced):
“TAPE” and “E” flash.
Audio channel level meter:
When the CH-1/2 / CH-3/4
switch is set to CH-1/2, the
audio channel level 2 is
displayed.
When the CH-1/2 / CH-3/4
switch is set to CH-3/4, the
audio channel level 4 is
displayed.