Filter
Top Products
HELP
SAL35F14G (1.4/35G) (35mm F1.4G)
HELP20
Adhesive bond (LOCTITE 460) (Note)
Note: Use adhesive bond (LOCTITE 460) or an equivalent article.
Do not use what becomes white after drying like quick-drying glue.
Apply the adhesive bond (LOCTITE 460) to the tip of mount guide mark and install it to the G ornamental block.
HELP21
Adhesive bond (LOCTITE 460) (Note)
Note: Use adhesive bond (LOCTITE 460) or an equivalent article.
Do not use what becomes white after drying like quick-drying glue.
Adhesive bond (B-10): J-6082-612-A
1. Apply a little amount of the adhesive bond (LOCTITE 460) to the indicated portions of focus hold button base.
2. Apply the adhesive bond (B-10) to the tip of one screw shown in figure and tighten the screw.
3. Perform “4-8. FOCUS HOLD BUTTON CHECK (FOCUS HOLD BUTTON)”.
ft
m
Mount guide mark
Apply the adhesive bond (LOCTITE 460)
to the tip mount guide mark
G Ornamental Block
Focus Hold Button Base
Click Plate
Dust Protection Tape
Focus Hold Button
Washer
Apply the adhesive bond (B-10)
Apply the adhesive bond (LOCTITE 460)