Filter
Top Products
4-27
SAL35F14G (1.4/35G) (35mm F1.4G)
Screw Screw Brush Base Plate
4-7. FOCUS BRUSH POSITION CHECK/ADJUSTMENT
4-7-1. Focus Brush Position Check (Search Focus Adjustment Point)
Equipment
• Personal Computer
• Finished Inspection JIG
• Lens Adjustment Program (ActuatorChecker.exe)
1. Preparations
1) Connected to equipment with checking lens. (Refer to Section 4-1-3.)
2) Start up of “ActuatorChecker.exe”.
3) Click [Set up], and perform the initial setting. (Refer to Section 4-1-4.)
2. Checking Method
1) Set the focus position to infinity position.
2) Remove the beam leather, confirm that can see the brush base plate.
3) Loosen two screws fixing the brush base plate.
Fig.4-7-1
4) Click the [Search Focus Adj Point].
Fig.4-7-2