Filter
Top Products
10
Hookups and Settings
Step 1: Connecting the Aerial Cable
Connect the aerial cable by following the steps below. Do not connect the mains lead until
you have made all the connections.
To watch TV in standby mode, set “Standby Mode” to “Mode 2” in “Step 3: Easy Setup”
(page 13) or use a splitter (not supplied) to divide aerial input signals between the TV and the
recorder.
1 Disconnect the aerial cable from your TV, and connect it to AERIAL IN on the rear
panel of the recorder.
2 Connect AERIAL OUT of the recorder to the aerial input of your TV using the supplied
aerial cable.
Hard disk recorder
TV
to aerial input
to AERIAL OUT
to AERIAL IN
Aerial cable (supplied)
: Signal flow
Wall