Filter
Top Products
40
Other Settings
• Off: Normal scanning
• On: While scanning, the scanner interrupts every 2
seconds and checks the priority channels in each
unlocked system. Priority channels in lower
priority key numbered systems (starting from 1) have
highest priority. Pri appears when you select this mode.
• PLUS ON: The scanner only scans priority channels in
unlocked systems. Pri flashes when you select this
mode.
Using the Backlight
Set Backlight E
• 10 sec The backlight stays on for 10 seconds after
you press + .
• 30 sec The backlight stays on for 30 seconds after
you press + .
• Squelch The backlight turns on when the squelch
opens then stays on for 5 seconds.
• Keypress The backlight turns on when any key is
pressed then stays on for 10 seconds.
• Infinite The backlight turns on when you press
+ then stays on until you press + again.
Pressing any key while the backlight is on extends the
backlight period. Pressing + while the backlight
is on turns off the backlight.
Initializing the Scanner’s Memory
Important! This deletes all preprogrammed data
except for the band plan and custom search range.
To initialize the scanner’s memory, turn off the scanner.
Then, press 2, 9, and Hold while turning it on.
Notes:
• If you initialize the scanner after changing the band
plan, custom search range is adjusted to match to the
band plan.
Menu
Func
Func
Func
Func
Func
SC230 Paper OM 062206.fm Page 40 Friday, July 21, 2006 7:39 PM