Filter
Top Products
73
Using the Close Call Feature
• The Close Call feature works better with some types
of transmissions than others. It might not correctly
display frequency information for transmitters using a
highly directional antenna (such as an amateur radio
beam antenna) or if there are many transmitters
operating at the same time in the same area.
Setting Close Call Options
1. Press then turn the scroll control until Close Call
appears. Then press E. Close Call feature options appear.
2. Turn the scroll control to select an option.
• Close Call Only: Lets you set the scanner only for
Close Call searching. The scanner does not scan
frequencies or channels when this option is turned on.
To select this option, press E.
• CC Auto Store: Lets you select whether the
scanner automatically stores Close Call hits into
channels. If you turn this option on, the scanner
starts Close Call mode and stores any Close Call
hits, up to the maximum you specified in the Max
Auto Store setting. If the scanner stores more hits
than this setting, it stops Autostore operation.
Turn the scroll control to display an option, then
press E.
• Set CC Mode: Lets you select the Close Call
mode. If you turn this option on (CC DND, CC
PRI), the scanner sets itself to its Close Call
settings about once every 2 seconds. Turn the
scroll control to display an option, then press E.
You can also toggle this setting by pressing
then .
Notes:
• CC DND - Close Call does not work while
monitoring a transmission.
• CC PRI - Close Call works even if there is a
transmission.
Menu
Func
SC230 Paper OM 062206.fm Page 73 Friday, July 21, 2006 7:39 PM