Filter
Top Products
42
Other Settings
• 38400 bps The baud rate is set to 38,400 bps.
• 57600 bps The baud rate is set to 57,600 bps.
Cloning the Scanner
To clone (copy) data from one USC230 scanner to another
USC230 scanner, you must first connect the scanners to
each other using the included connection cables and a
DB9 null modem adapter and DB9 gender changer
(neither included), available at most computer stores.
Then you must set one scanner as the master (source)
and the other as the slave (destination).
Plug the smaller end of each of the included connection
cables into Remote on the right side of each scanner.
Then connect the other end of the cables together using
the null modem connector and gender changer.
Then set up both scanners.
Xfer Information E
WIRED Clone E
• Master This will be the master (source) scanner.
• Slave This will be the slave (destination) scanner.
(Master scanner) E
Clone Master Press SCAN Key
(Slave scanner) E
Clone Slave Press SCAN Key
When you are ready to clone the scanner, press Scan on
the slave scanner first, then on the master scanner.
The master scanner checks the connection between the
two scanners, then transfers its data to the slave scanner.
When the transfer is complete, Complete appears on
both scanners. If the transfer did not work, Error appears
on the master scanner.
Menu
SC230 Paper OM 062206.fm Page 42 Friday, July 21, 2006 7:39 PM