Filter
Top Products
56
Programming/Editing Optional Settings
Notes:
• If you select 0, the scanner stays on the system for a
minimal time (only long enough to check current
system activity).
• The default setting is 2 seconds for each system.
• All unlocked channels will be scanned at least once
regardless of this setting.
• The scanner moves to the next system after the hold
time expires, any current transmission ends, and the
channel delay time expires.
Setting the Channel Delay Time
program system E
Select the system E
Edit Sys Option E
Set DELAY Time E
This setting controls how many seconds the scanner
waits after a transmission ends before resuming
scanning. Select a value from 1-5 or Off, then press E.
Notes:
• The default setting is 2 seconds for each system.
• This setting applies to all channels within the system.
Setting Data Skip
program system E
Select the system E
Edit Sys Option E
Set DATA SKIP E
This setting controls how the scanner behaves when it
stops on a channel that has a data signal.
On - the scanner stops briefly on the channel, but then
immediately resumes scanning automatically. Press E to
select.
Off - the scanner remains on the channel until the
transmission stops. Press E to select.
Menu
Menu
SC230 Paper OM 062206.fm Page 56 Friday, July 21, 2006 7:39 PM