Filter
Top Products
47
Programming Radio Systems
8. Set the modulation
type (Auto is almost
always the correct
choice), then press E
9. Set the attenuator (turn
it on to eliminate
interference from other
sources), then press E
10. Set the channel priority
(turn it on if you want
the scanner to interrupt
operation every few
seconds to check for
transmissions by this
driver), then press E
11. Set alert (turn it on if
you want the scanner
to sound a special alert
when this car
transmits), then press E
12. If you have another
frequency to enter for
this driver, press E
then repeat from Step
5. Otherwise, press No
13. To enter another car in
this race, press E then
repeat from Step 3.
Otherwise, press No
14. When you finish, press
Scan to begin
scanning the race
Set Modulation
Auto
Set Attenuator
Off
Set Priority
Off
Set Alert
Off
Another Freq for
This driver?
Another Car For
This Race?
Complete
Press SCAN key
SC230 Paper OM 062206.fm Page 47 Friday, July 21, 2006 7:39 PM