Filter
Top Products
7-8
Log Messages on the Camera
Log messages are classified into the following 5 types.
Note
If no content is recorded in a log for approximately two hours, “-- MARK --” will be recorded in the message area.
Application (camera) messages
W001 Starting and stopping of system [info]
W030 Startup and shutdown of WebView Livescope Client [info]
W031 Transmitted video data size [info]
W040 Clearing to external memory [info]
W101 Invalid user name [notice]
List of Log Messages
Category Level Code Fault level
crit Error 4xx Software-level failure (Task operations will stop)
err Error 3xx Operational error (Operations will continue)
warning Warning 2xx Non-operational error
notice Warning 1xx Error external to the system
info Information 0xx Information on normal operation
Description %1 webview (W001)
%1 Starting or stopping
Meaning wvhttp server (webview) has started or stopped.
Description %1%2 host=<Host>, user=<User>, prio=<Priority> (W030)
%1 W: WebView session, V: Session-less video client, N: Session-less event client
%2 +: Connect, -: Disconnect
Meaning The camera server client was connected or disconnected.
Description %1= host=<Host>, user=<User>, video=<jpg | h264>:<Number of frames> (W031)
1% W: WebView session, V: Session-less video client
Meaning When a client disconnected, the total data that was sent to the client displayed in number of frames.
Description %1 the image storing - %2 (W040)
%1 Starting or stopping
%2 Reason for starting/stopping
Meaning Started or stopped clearing stream recording to external memory.
Description user <User name> not found (W101)
Meaning The camera was accessed by an unauthorized user.